Provision CHALLENGER PRO Especificaciones descargar pdf (Pagina 42)

CHALLENGER PRO

System

Slave Address Explained

wire CHALLENGER PRO system is capable of connecting up to 4 Monitors in one apartment, which means they will

have the same

User Code, and will be called simultaneously. In this condition, the Monitors should be programmed as below:

• 1. All the Monitors of same apartment must be programmed with the same User Code on the DIP switches.

• 2. There is only one master Monitor in the one apartment, and the Slave Address of the master Monitor is set to 0.

Each Slave Monitor should be set from 1~3.

• By default, Monitor’s Slave Address is pre

set to 0(master Monitor).

• When Door Station calls, only the master Monitor will turn on the screen, the slave Monitor will only ring.

Master Monitor Slave Monitor 1 Slave Monitor 2 Slave Monitor

Slave

Address

Slave

Address

Slave

Address

Slave

Address

Please note, when called by Door Station, all Monitors will ring, however, only the Monitor which Sub User Code was

programmed to 0 will turn on the screen.

Programming Slave User Code is by means of Monitor Menu, in the Main

- -

> Setup

- -

> Advance Set page(a password

will be required before enter the setting, the password is:

2008

), operate as below:

• The Slave Addr Set item is for the master and slave

Slave Addr

Set -- 0

Guard

Unit Set -- 0

Date

and

Time

set...

Other

settings...

Informations...

Exit

user code setting, default is set to 0 for master user

code. It can be change to 1, 2 or 3.

• The Guard Unit Set item is for Guard Unit Monitor

setting, the default it set to 0, if set to 1, this Monitor is

become a Guard Unit Monitor.

H o m e

ig e n t S y s

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 48 49 50

Comentarios a estos manuales

Sin comentarios

Provision CHALLENGER PRO Especificaciones Pagina 42

Comentarios a estos manuales